Cisco ONS 15400 Series Release Notes for Cisco ONS 15454, Release 8.6.1 (01/06/2013)

Table Of Contents

Release Notes for Cisco ONS 15454
Release 8.6.1

About Release 8.6.1

Contents

Changes to the Release Notes

Caveats

Alarms

CSCsl18519 —One CARLOSS and TPTFAIL alarm reported with dual failure on ports of CE-MR-10 card

CSCsm16960 —AUTO RESET alarm cleared before activation

CSCsm19928 —AS-MT condition not persistent against subtended shelf TCC software reset

CSCsm32308— Roll-pend(NA) and UNEQ-P(CR) alarms move to Conditions pane on soft reset of active TCC

CSCtd11068—CE-100T-8 card link is down with no alarms

CSCta72945—SWMTXMOD Alarm on MRC Cards

CSCsy69110—ADD Port Alarm not Raised

CSCtd60987—RFI-V alarm does not clear on ONS 15454 NEs in the CTM

CSCtf22211—Bridge and Roll valid signal is inconsistent

BLSR Functionality

CSCdv53427— Protection vulnerabilities in two-ring, two-fiber MS-SP ring configuration

Common Control Cards

CSCsy91761—Constant TCC Reset

CSCsz39798—Constant TCC Reboot

CTC

CSCsy14945—CTC cannot manage either nodes of the same version of higher maintenance version, than its core version

CSCsy82228—CTC Network discovery is slow

CSCtb81645—CE-MR STS pool allocation is incorrect in CTC

CSCtc46543—CTC circuit creation wizard window hangs during OCHNC circuit creation

CTC Release 8.5.x unable to manually route STS1 from DS3 to DS3XM-12 card

CSCtg96470—BITS-OUT clock is not in sync with the incoming clock

CSCta95590—Provisioning strip sends wrong BPDU configuration for NNI ports

CSCtg92049—Incorrect pool allocation on CE100T-8 Card

Data I/O Cards

CSCsq02815—Negative values for gfpStatsRxCRCErrors and ifInPayloadCrcErrors parameters in CTC for CE-MR-10 cards

CSCsq24903 —First data frame sent on POS circuit is lost on CE-MR-10 card

CSCte67178—Link does not recover between CE-1000 and Sycamore cards

CSCso94644—LCAS VCG Member Rx side in Add State condition persists after hard reset of CE-MR-10 card or ML-MR-10 card

CSCsm78387—PDI-P alarm causes the Ethernet port to go down when members are deleted on open-ended HW-LCAS VCAT circuit

CSCsq20532—Traffic hit of 25 ms occurs in a low-order LCAS circuit

CSCsy16814—Traffic drop is observed when port state is changed from OOS-DSBLD to IS

CSCtc44604—First 32 DCC Area IDs are restored after the upgrade

CSCtg93566—IDLE does not clear on few HW-LCAS members

DWDM

CSCsx49926—Egress WRR scheduling does not work for frames > ~1500 on GE_XP card

CSCsg22669—Traffic hit greater than 50 ms but less than 60 ms on MXP-2.5G-10E in Y cable configuration with fiber cut

CSCsf04299 —WTR time does not trigger switch back of protection

CSCsm82422—CARLOSS alarm not raised when power is turned off on MXP-MR-10DME cards

CSCei19148—Client momentarily enabled and emits light before squelching due to the trunk OOS,DSBLD condition

CSCsb47323 —Unexpected RFI condition raised with OTUk-BDI for MXP-MR-10DME-C and MXP-MR-10DME-L cards

CSCsb94736—MXP-MR-10DME card fails to detect the login message after fault condition

CSCsc36494—Manual Y-cable switches with squelching turned off in the MXP-MR-10G card causes Fiber Channel link with Brocade switches to go down

CSCsc60472—CTC is not able to discover TL1 OCHCC circuit provisioned over ITU-T line card

CSCsg10008—Y-cable protection switch time higher than 50 ms in GE_XP and 10GE_XP cards

CSCse97200 —Local and Express order-wire circuits do not work on ADM-10G card

CSCei87554—IfInErrors counter does not report performance parameters

CSCee45443 —FICON bridge in the MXP-MR-2.5G card transitions to SERV MODE

CSCsz94689—Incoming traffic received through any port on the affected card may flow to other Service Provider VLANs

CSCtb33916 —After an upgrade, traffic is discarded on a newly created VLAN

CSCtc54159—Traffic drops if CVLAN coincides between the range and single entry on different SVLAN

Electrical I/O Cards

CSCsq13945— DS3-12 card does not boot up in release 8.0 and later

CSCsq98420—DS1 port state (under a DS3 port) moves to OOS,DSBLD state on deletion of first VT circuit

Hardware

CSCei36415 —Retrieving Gigabit Interface Converter (GBIC) inventory for FC_MR-4 returns nothing for CLEI code

CSCeb36749 —In a Y-cable configuration, CARLOSS alarm is major and affects service even though traffic is fine

Maintenance and Administration

CSCse38590— Station reports "remote WTR" on a space even though the neighboring station is not advertising Wait to Restore (WTR) state

CSCsd44081—Series of crashes and reboots occur when policy-map includes approximately 200 class-map entries and policers

CSCse23518—RPR SPAN-MISMATCH alarm not reported correctly

CSCse53133—RTRV-COND-STS does not display path alarms on BLSR protect path

CSCsg10963—Connections remain in OOS-AU,FLT after roll is canceled

CSCse91968—AINS-to-IS transition on BLSR four-fiber Protect does not function properly

CSCsm04659—CTC does not report TL1 circuits when the software is upgraded to Releases 8.5.1 and 8.6

CSCsm08019— MXP-MR-10DME card carries traffic even if trunk port is in OOS,DSBLD state

CSCsm43960— Intermediate switch to protect occurs when TIM alarm is generated on MXPP-MR-2.5G card

CSCsm61886 —Less accuracy of the Link Integrity timer on CE-MR-10 card

CSCsg42366—Traffic outage occurs when FPGA upgrade is done with manual switch on Y-cable

CSCta11737—Soft reset of CE card places IS-AINS port to IS when soak timer is set to zero

CSCta87573—40-MUX-C card does not report CHAN-RX power when COM-TX port is not in IS or MT state

NCP

CSCdu82934—Failure of VT circuit creation

Optical I/O Cards

CSCei26718 —Different alarm behavior between one-way and two-way VT/VC circuit creation on path protection

CSCin29274—Same static route on two interfaces fails

CSCta42253—MRC card remains in OOF state

Path Protection

CSCee53579— Traffic hits occur in unprotected to path protection topology upgrade in unidirectional routing

SNMP

CSCsy42909—SNMP trap do not display port/slot number correctly for OCHTERM-INC alarm

TL1

CSCsc41650 —Node reboots during DS3XM card pre-provisioning

CSCtf50729—TCC crashes when debug commands are executed

Resolved Caveats for Release 8.6.1

Alarms

CSCsu40460—External remote alarm relay is not set correctly

CSCsm32278 —Alarms at GFP level on MXP-MR-10DME cards do not trigger FLT state on port

CSCsk20948—VT alarms with invalid aid is raised on XM12 ports

CSCsq68460—LCAS-RX-FAIL and LCAS-RX-DNU alarms are not reported for AIS-V and LOP-V for MLMR and CEMR cards

CTC

CSCsr89201—Unable to launch CTC with emsAccessState=secure after upgrade

CSCsr47355—Unable to cut new hybrid node into an existing hybrid MSTP ring

CSCsq73116—PPC does not work on secure mode node

CSCsq88986—Filler card prevents enabling MSTP multishelf

CSCsv01621—It is not possible to enter in the WXC card panel

CSCsl76583—Select Affected Circuits does not work for PLM-P

CSCtf77988—NMS support to display input voltage and ambience temperature

Cross Connect Cards

CSCsy86915—Extra STS is utilized in the first VT cross connect created on an STS

CSCtd46366—Cross-connect loopback on monitor circuit affects the traffic of the original circuit

Data I/O Cards

CSCsm09512—Packet drop and VCG-DEG condition observed after hard reset of CE-MR-10 card

CSCso66424—LCAS VCG Member Rx side in Add State condition persists after hard reset of CE-MR-10 card

CSCsq16464—Traffic on nodes duplicates on ML-series cards

CSCsu02307—Unable to add members with SD-P alarm present on one member

CSCsw64346—UNEQ raised on CEMR-10 HW LCAS circuit after XC switch

CSCsu02236—Members of the VT-1.5 LCAS circuits are in idle state

CSCsr67830—High traffic hit seen with larger HW-LCAS circuits with fiber pull

CSCsr06085—Error message on CPU switching packets greater than 1500 bytes in length

CSCsm99133 —Packet loss on CE-MR-10 cards running more than 8.5 Gbps traffic during software upgrade

CSCso55327—TCC switch on CE-MR-10 and ML-MR-10 cards causes a traffic hit of up to 180 ms

CSCsq20532—Traffic hit of 25 ms occurs in a low-order LCAS circuit

CSCsq24264—Traffic hit on CE100T-8 cards during an upgrade from release 8.5.0 to release 8.5.2 or 8.6

CSCsq52786—Link Integrity does not work for HW-LCAS circuits

CSCsq55568—High traffic hit while upgrading from pre 9.00 load on CE-MR-10, CE-MR-6 cards

CSCsq77755—UNEQ alarmed HW-LCAS member will go into In-Group when CTX or XC card is reset

CSCsr41260—RPR convergence time is more than expected (50 ms) in ML-100X

CSCsr78331—Cannot create a STS-1-2v or a STS1 circuit on the CE-100 card

CSCtc66943—Link does not come up when autonegotiation is enabled

CSCtf10958—Path PMs are displayed for CE-MR/ML-MR Cards

CSCse74833—GFP-CSF is not detected by CE-MR-10 and ML-MR-10 cards

DWDM

CSCso73947—E port is down after MXP-MR-10DME card power up

CSCsu06528—GE_XP and 10GE_XP Trail Trace receive incorrect message

CSCsx55119—Ingress COS remarking not working for NNI ports on GE_XP card

CSCsw49064—GR3 protection is not triggered by SD or SF alarms on trunk ports

CSCsu49109— Y-cable does not switch for client syncloss on TXP-MR-10E card

CSCsr60270—Upgrade issues in GE_XP/10GE_XP cards

CSCsr22181—IPG change for Copper SFP

CSCsq99089—Traffic does not flow on the fast automatic protection switching (FAPS) circuit

CSCsq99680—Unwanted PM updates and alarms occur

CSCsq78030—Continuous squelch asserts or clears are observed on MXP-MR-2.5G card

CSCsq78337—Unable to provision ONS-SE-G2F-LX= (10-2273-02) on a TXP-MR-2.5G card for ISC3

CSCsq33614 —Hard reset of MXP-MR-10DME and MXP-2.5G-10E cards raises IMPROPRVML alarm

CSCsq46283— Packet loss on MXP-MR-10DME cards provisioned with 4G or 4G FICON

CSCsl70268 —Severity is not cleared when the raised alarm is cleared

CSCso92518—TIM alarm is not cleared on TXP-MR-10E and MXP-MR-10DME cards

CSCsq16317—GE-XP card in L1 mode reports FEC Uncorrected Word (UNC-WORD) condition

Electrical I/O Cards

CSCsq48070 —Standby TCC crashes during database restore

CSCsq58173—TCC reboots when configuring DS3XM12 or mixed 1:1 or 1:N PG

CSCsu20391—FE-AIS and RAI alarms are incorrectly reported

CSCsu39177—After deletion of VT circuit and creation of STS-1 circuit, there is traffic loss

CSCsu47448—For DS1 FEAC, loopcode in DS3 framing FAC is inserted on odd DS1 ports

CSCtb74439—DS3XM cards insert VT-AIS downstream

Maintenance and Administration

CSCsg16500—ROLL-PEND condition seen for VT circuits on CTC conditions pane

CSCsl76684—Delay in AIC-I card becoming active

CSCsm14521—Inconsistency between LOCKOUT command status and switching status on Y-cable protected MXP-MR-10DME card

CSCsm25619 —Traffic is not restored after card reset

CSCtd42075—Upgrade of DS3XM-6 card to DS3XM-12 card leaves first 6 ports of DS1's Unframed

NCP

CSCsu10564—DCN-EXT: OTS PPC problem with OSPF enabled on LAN

Optical I/O Cards

CSCsr76682—Bit errors observed on OC192XFP after both XC cards reboots

CSCsv54817—STS-96c circuits do not work with OC192XFP cards

CSCsl87931— ALS condition permanently lost when manual restart is performed

CSCsu50003—Traffic loss when concatenated unidirectional circuit is provisioned through 1 + 1 protected clients

New Features and Functionality

Related Documentation

Release-Specific Documents

Platform-Specific Documents

Obtaining Optical Networking Information

Where to Find Safety and Warning Information

Cisco Optical Networking Product Documentation CD-ROM

Obtaining Documentation and Submitting a Service Request

 

Downloads

22:06 | Lien permanent | Commentaires (1) | |  del.icio.us | | Digg! Digg |  Facebook | |  Imprimer |