Ok

En poursuivant votre navigation sur ce site, vous acceptez l'utilisation de cookies. Ces derniers assurent le bon fonctionnement de nos services. En savoir plus.

Cisco ONS 15400 Series Release Notes for Cisco ONS 15454 SDH, Release 8.5.4

Pin it! Imprimer

Table Of Contents

Release Notes for Cisco ONS 15454 SDH
Release 8.5.4

Contents

Changes to the Release Notes

Caveats

Alarms

CSCsv30593—AIS-V alarm does not clear

CSCsv30867—The alarms do not clear after cross-connect side switch

CSCsw98487—PROV-MISMATCH alarm is not raised when client port is in Unlocked state

CTC

CSCsv14375—Shared secret key corrupt after upgrade

CSCsy14945—CTC cannot manage either nodes of the same version of higher maintenance version, than its core version

Data I/O Cards

CSCsx75218—VC12 VCAT circuit members may not come-up and report LOP alarm

CSCsy16814—Traffic drop is observed when port state change from OOS-DSBLD to IS

DWDM

CSCsu81842—Circuit not created through add and drop node with by-pass patchcords

CSCsv01621—Unable to open the card configuration panel

CSCsx17868—The MXP-MR-10DME card continuously reboots after FPGA upgrade

CSCsz38549—VOA FAIL alarm is raised when channels are added

CSCsz94689—Incoming traffic received through any port on the affected card may flow to other Service Provider VLANs

CSCta49163—Unsupported Y-cable allowed through TL1

CSCtb16483—PPC created through TL1 is not discovered properly in the CTC

CSCtb33916 —After an upgrade, traffic is discarded on a newly created VLAN

Optical I/O Cards

CSCsu80809—Data rate can be changed when there are active circuits and DCC connections

Path Protection

CSCta44268—In ADM10G, for path protected circuits on STSs greater than 3, traffic hit of around 2000 ms is observed

Performance Monitoring

CSCta27911—MS-UAS is reported in ONS 15454-SDH node

TL1

CSCsv45464—The RTRV-OCHNC command with AID=ALL does not return any information about the existing cross connections

CSCsv71398—The RTRV-MOD command displays LBC and OPT parameters with invalid values

CSCsw92329—TL1 do not initialize PM counts on all ports of MRC card

CSCsz81750—Traffic loss for 50 ms on MXPP-MR-2.5G and TXPP-MR-2.5G cards

CSCta30336—Internal communication error reported for a preprovisioned card

Resolved Caveats for Release 8.5.4

Alarms

CSCsy69110—ADD Port Alarm not Raised

CSCsz67629—On E1-42 protection switching, LOS alarms on ports 23 and 27 are cleared

CSCsz84817—High Laser Bias and Rx Power alarms seen on ONS-XC-10G-SR-MM XFP

CSCta72945—SWMTXMOD alarm on MRC cards

Common Control Cards

CSCsx37297—FTP port issue for TCP connect scan

CSCsy91761—Constant TCC Reset

CSCsz08846—Generation of two contradictory logs

CSCsz39798—Constant TCC Reboot

CSCsz81891—Issue in database partitions not reported

CTC

CSCsm85843—CTC displays the STS circuit in ROLL_PENDING state when Bridge and Roll is performed

CSCsq73116—PPC is not working on secure mode node

CSCsr01562— PPC links disassembled

CSCsw96807—PPC cannot be deleted in secure mode node

CSCsx81421—Trouble managing SoTL1 tunnels using CTC

CSCsy74949—Incorrect NE default values downloaded

CSCsy82228—CTC network discovery is slow

Data I/O Cards

CSCsl65143—Traffic outage on G1K and G1000 cards

CSCso55327—TCC2 card switch causes unexpected high traffic outage with all circuits

CSCta44387—UNEQ-P does not trigger link integrity on CCAT circuits

CSCtc66943—Link does not come up when autonegotiation is enabled

DWDM

CSCsj97288—PROV-MISMATCH alarm raised on TXP_MR_10E Card

CSCsq78337—Cannot provision ONS-SE-G2F-LX SFP for ISC3

Electrical I/O Cards

CSCsl81293—Traffic loss on DS1 card

CSCsu92843—BERT on DS3-XM12 card does not inject bit errors

CSCsz59607—Traffic drops on DS3-XM card when Signal Degrade alarm threshold is cleared

CSCta24511—LoF on DS3-XM6 card does not cause DS1 AIS

Hardware

CSCsm55562—Payload PM not reported on active GigabitEthernet port when CARLOSS is raised

Optical I/O Cards

CSCsv54817—UNEQ-P alarm is raised on STS-96c circuits with OC-192 XFP

CSCta42253—MRC card remains in OOF state

Path Protection

CSCsk46370—Error rate injection non functional

CSCsw49064—GR3 protection is not triggered by SD or SF alarms on trunk ports

CSCsx17026—Traffic on protect path not restored

CSCsy26595—Traffic does not recover after active and protect paths fail

CSCsz06764—SF-V condition does not clear

New Features and Functionality

Link Integrity Soak Timer

TL1 Gateway and ENE Sessions

Related Documentation

Release-Specific Documents

Platform-Specific Documents

Obtaining Optical Networking Information

Where to Find Safety and Warning Information

Cisco Optical Networking Product Documentation CD-ROM

Obtaining Documentation and Submitting a Service Request

 

 

Downloads

Les commentaires sont fermés.